Xv-dv424 manual

The exclamation point within an equilateral. The lightning flash with arrowhead symbol,. This equipment is not waterproof. To prevent a fire. To prevent a fire hazard, do not place any naked. Operating environment temperature and humidity:. Do not install this unit in a poorly ventilated area, or in. This product is a class 1 laser product, but this. To ensure continued safety, do not remove any covers.

Refer all servicing to qualified personnel. The following caution label appears on your unit. The voltage of the available power supply differs. Be sure that the. Before plugging in for the first time, read the following. This product complies with the Low Voltage Directive. Thank you for buying this Pioneer product. Please read through these operating instructions so that you will know how to operate your model properly. When installing this unit, make sure to leave space. Slots and openings in the cabinet are provided for.

Limit of measurement. Frequency range. With 9kHz step. With 10kHz step. Loop antenna. Power requirements. AC V, 60 Hz. Power consumption. Power consumption in standby. Remote control. Video cable yellow plugs. AM loop antenna. FM antenna. Power cord. Setup Guide. Operating instructions. Warranty Card. WARNING Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating.

To prevent fire hazard, the openings should never be blocked or covered with items such as newspapers, table-cloths, curtains or by operating the equipment on thick carpet or a bed. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power.

Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the AC outlet when left unused for a long period of time for example, when on vacation. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc.

Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

If connected to an AC outlet, the cut-off plug can cause severe electrical shock. Make sure it is properly disposed of after removal. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time for example, when on vacation. Any failure due to use for other than household purposes such as long-term use for business purposes in a restaurant or use in a car or ship and which requires repair will be charged for even during the warranty period.

There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer if you purchase a similar new one.

For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health.

Speaker Setup Guide 5 En English Chapter 2 Speaker Setup Guide Safety precautions when setting up When assembling the speakers, lay them down flat on their side to avoid accidents or injury.

Make sure to use a stable surface when assembling, setting up, and placing the speakers. Once you have aligned the stem and base, secure with the small screws at the points shown below. In accordance with the procedures or instructions described in this manual, adjustments should be performed. For optical pickups, tape-deck heads, lenses and mirrors used in projection monitors, and other parts requiring cleaning,. Lubricants, glues, and replacement parts.

Appropriately applying grease or glue can maintain the product performances. But improper lubrication or applying. By following the instructions in this manual, be sure to apply the. For replacement parts or tools, the prescribed. Shipping mode and shipping screws. To protect the product from damages or failures that may be caused during transit, the shipping mode should be set or. You should conform to the regulations governing the product safety, radio and noise, and other regulations , and.

This player is compatible with a wide range of. Playable discs. Front, Center, Surround. DVD fs: 96 kHz, bit. DVD system, video CD system and.

Total harmonic distortion. Wow and Flutter.